Datcon DT4200 Operating Instructions Manual page 11

DT4200
Mounting with the
mounting clamps
20181113-V0
2. Put on the enclosed seal onto the instrument case from
the rear side and fit it to the instrument holding frame
(Figure step 2).
3. Put the instrument into the prepared cut-out until it
possible and check the fitting of the seal between case and
mounting surface.
4. Put one of the enclosed mounting clamp onto the tip of a
screwdriver (A) and put the clamp with the help of the
screwdriwer into the hole on the side of the instrument.
5. Push the mounting clamp with your finger tip as far as
you can while keeping the case in it's position.
Repeat the 4., 5. steps with the other clamp.
Please do not exercise forces higher than necessary, as it
may cause damages to the clamp.
11