Datcon DT4200 Operating Instructions Manual page 18

Messages of critical
errors






During measuring


During code writing




During setting up












18
A/D failure (Service: AD Hardware)
EEPROM failure (Service: EEPROM Hardware)
EEPROM write error (Service: EEPROM Protected)
Calibration error (Service: Calibration)
Default factory settings (Service: Default Factory Settings)
The last saving was not successful (Error: Last Save)
20000 - The value presented on the display is twenty-
thousand
-20000 The value presented on the display is minus twenty-
thousand
Code? (Code)
Bad Code (Bad Code)
A User login took place (User)
A Supervisor login took place (Supervisor)
The typed number is lower than allowed (Low Limit)
The typed number is higher than allowed (High Limit)
Low numeric value not possible to display
High numeric value not possible to display
Re-type it please (Re-type)
Automatic escaping (Auto Escape) - after 1 minute
Exit from the setting (Exit)
The instrument is making calculations, please wait
(Busy)
The requested operation has been completed (Ready)
The saving of the settings is being done (Save)
No, I don't want this menu (No)
Yes, the menu can be started (Yes)
DT4200
20181113-V0