Table of Contents
Advertisement
Section 9. LONG RANGE RADIO
General Information
Check availability of Model 7720PLUS or 7820 long range radio.
If output to long range radio is selected, all messages that are programmed to
go to the primary telephone line receiver will also be sent to the 7720PLUS or
7820 long range radio. These messages will be in Contact ID format (not
affected by entry in field 46).
The data line is supervised, as well as certain functions in the radio. If
communication is lost or a trouble develops, a message will be attempted to be
sent via both radio and telephone to the central station.
For complete information, see the manual that accompanies the radio.
Connection
Connect the data in/data out terminals and voltage input terminals of the Long
Range Radio to the control's keypad connection points, terminals 4, 5, 6, and 7
as shown below.
Programming for Long Range Radio
1. With at least one keypad connected to the keypad terminals on the control,
power up the system temporarily. If you had previously connected the AC
transformer to the control panel, you need only plug in the transformer (to
120VAC outlet) to power up the system.
2. Enter the programming mode by keying the following on the Alpha keypad:
INSTALLER code (4 1 1 1) + 8 + 0.
3. Press 27 OUTPUT TO LONG RANGE RADIO
Enter 1 when using a Long Range Radio; enter 0 if not (default is 0).
If yes is selected, any dialer report programmed to report to the PRIMARY
phone number (in field 47) will be sent, as well, via long range radio. All
dialer and long range radio reports will be in Contact ID format (regardless
of the selection made in field 46).
Full Trouble and Restore messages are sent.
5. Program the long range radio for device address "3" on the keypad lines.
6. Exit the programming mode by keying 99.
BLACK
4
RED
5
GREEN
LONG RANGE RADIO
6
YELLOW
7
CONTROL
TERMINALS
Figure 12. Long Range Radio Connections
– 51 –
7720 PLUS/7820
Hide quick links:
Advertisement
Table of Contents
