5800 Series Transmitter Setup; 5800 Series Transmitter Input Loops; 5800 Series Transmitter Input Types - ADEMCO N7227V5 Installation Instructions Manual

5800 Series Transmitter Setup

General
Information
5800 Series
Transmitter Input
Loops
U L
5800 Series
Transmitter Input
Types
• If the keypad does not beep, re-orient or move the transmitter to another
location. Usually a few inches in either direction is all that is required.
3. Mount the transmitter according to the instructions provided with the
transmitter.
4. Exit the GO/NO GO test mode by entering Installer Code + (OFF ).
You should now proceed to "Check-Out Procedure for Wireless Zones" at
the end of this section.
5800 series transmitters have built-in serial numbers that must be entered
("enrolled") into the system using the
the control via the downloader. 5800 series transmitters (except 5827
described separately) do not have DIP switches.
Each transmitter's zone number is programmed into the system in
Some transmitters, such as the 5816 and 5817, can support more than one
"zone" (referred to as loops or inputs). On the 5816 for example, the wire con-
nection terminal block is loop 1, the reed contact is loop 2. Each loop must be
assigned a different zone number and entered separately.
For button transmitters (wireless "keys" ), such as the 5804, you must assign a
unique zone number to each individual button used on the transmitter. Each
button on the transmitter also has a pre-designated loop or input number,
which is displayed when entered.
Refer to 5800 Series Transmitter Input Loop Identification in the separate
Programming Guide manual
The 5816, and 5817 do not supervise their loop wiring for shorts Therefore,
for UL Household Burglary installations, the loop wiring may not exceed 3 ft.
Programming an RF House ID (01–31) in field
using 5827 or 5827BD wireless keypads. An RF House ID is not necessary
for other 5800 series transmitters and the entry should be left at "00" (default)
in those cases.
The 5827 wireless keypad reports low battery status as zone "00."
All of the transmitters described have one or more unique factory assigned
loop inputs. Each of the inputs requires its own programming zone (e.g., a
5804's four button inputs require four programming zones).
5800 Transmitters can be entered into the system as one of the following input
device types:
Input Device Type
"RF"
(Supervised RF)
"UR"
(Unsupervised RF)
"BR"
(Unsupervised Button
RF)
Do not install batteries in wireless transmitters until ready to use, as will be
indicated under "Programming the RF Transmitters (5800 RF Systems)" later
in this section. Though it is not critical to remove batteries after entering into
the system, it is recommended in order to avoid interference while entering
additional transmitters into the system.
– 31 –
56 or 83 interactive mode, or input to
24 is necessary only if
Description
Sends periodic check-in signals, as well as fault,
restore, and low battery signals. The transmitter
must remain within the receiver's range.
Sends all the signals that the "RF" type does,
but the control does not supervise the check-in
signals. The transmitter may therefore be
carried off-premises.
These send only fault signals. They do not send
low battery signals until they are activated. The
transmitter may be carried off-premises.
56 mode.