Ettan Ipgphor 3 Control Panel Functionality - GE Ettan IPGphor 3 Operating Instructions Manual

Hide thumbs Also See for Ettan IPGphor 3:

Table of Contents

5.3.1

Ettan IPGphor 3 control panel functionality

Introduction

IEF runs are programmed from theEttan IPGphor 3 Isoelectric Focusing System control

panel with up to ten user-defined IEF protocols, each with up to 9 steps per protocol.

Programmable functions including: rehydration time, platform temperature, current

limit, voltage limit for each step, voltage gradient or step and step duration.

Control unit keys

The following keys on the control panel are used to program Ettan IPGphor 3.

COMMAND

keys

EDIT

Left arrow

Right arrow

Ettan IPGphor 3 Operating Instructions 28-9635-51 AC

Function

Pressing the EDIT key in the edit mode toggles between the proro-

col identification screen with general settings for all steps and the

settings in the three first protocol steps.

The EDIT key switches the display to edit mode, in which protocol

steps can be programmed. (Refer to Section 5.3.3 Set protocol pa-

rameters, on page 75.

The EDIT key also allows the estimated run time remaining to be

viewed while the unit is operating.

The Left arrow key moves the cursor to the left. Moving the cursor

off the screen to the left repositions the cursor at the left side of

the next row. From the bottom row the cursor is repositioned on

the left side of the top row.

The Right arrow key moves the cursor to the right. Moving the

cursor off the screen to the right repositions the cursor at the left

of the next row. From the bottom row the cursor is repositioned

on the left side of the top row.

5.3 Perform a run from the control panel

5 Operation

Table of Contents