GE Ettan IPGphor 3 Operating Instructions Manual page 98

5 Operation
5.4 Run a pre-programmed protocol from the PC
5.4.2 Perform a run
Pause a run
Follow the instructions below to pause a run.
Step
1
2
Stop a run
Follow the instructions below to stop an ongoing run.
Step
1
2
Note:
Display graphics and data
Ettan IPGphor 3 Control Software provides graphics of the data (Voltage, Volt-hours and
Current) as it is retrieved from Ettan IPGphor 3.
The user can monitor and display the progress of any individual run from any one of
four different instruments being run in parallel.
98
Action
Click Pause button to pause an ongoing run.
The run is now paused which is indicted by the word Paused below the in-
strument control buttons.
Click Start button to proceed the run. The run is started from the same posi-
tion in the protocol from where it was paused.
Action
Press Stop. The run is now stopped. To indicate that the run has stopped,
Idle is displayed below the instrument control buttons.
The run is now stopped which is indicted by the word Idle below the instru-
ment control buttons.
While using Stop it is not possible to start the protocol again except from the
beginning of the protocol.
Ettan IPGphor 3 Operating Instructions 28-9635-51 AC