Intel ISP1100 Quick Start Manual page 16

Install the Riser/Add-in Card(s)
Perform the following procedure to install the riser, with the add-in card(s) attached, on the server
board (refer to Figure 12):
1. Align the riser card edge connector (A) with the mating riser connector on the server board.
(The connectors are keyed to mate in only one direction.)
NOTE
If you installed a low-profile card on the riser, make sure the right side of the
low-profile card bracket (B) fits into the narrow slot (C) on the right side of
the add-in card expansion slot.
2. Firmly press the riser/add-in card(s) straight down and all the way into the mating connector on
the server board.
CAUTION
If you installed only one add-in card, make sure the empty expansion slot has
a filler panel installed before you attach the filler panel retention bracket as
described in the following step. An open expansion slot will reduce the
cooling and EMI integrity of the server.
3. Use the Phillips screwdriver and the two screws (D) removed in the "Remove the Rear I/O
Filler Panel(s)" procedure to securely attach the filler panel retention bracket (E) to the top of
the server back panel.
16
Figure 12. Installing the Riser/Add-in Card(s)
D
A
Intel ISP1100 Internet Server Quick Start Guide
E
B
C
OMO9440