Intel ISP1100 Quick Start Manual page 7

Install the Processor Chip
Perform the following procedure to install the processor chip on the server board (refer to
Figure 3):
1. Grasp the end of the zero-insertion-force (ZIF) arm (A) and bend it out slightly until it
disengages from the socket tab (B).
2. Swing the ZIF arm up until it stops in the straight up position. The processor socket is now
unlocked.
3. Face the front of the server and orient the processor chip (C) with the notch (D) in the upper
left corner of the processor socket (E).
4. Gently place the processor chip on the socket so that the processor pins (F) mate exactly with
the corresponding socket pins (G). Do not force the processor into the socket since it takes
only a slight pressure to bend the pins.
5. With the processor in place, swing the arm (A) down until it snaps into the socket tab (B). The
processor is now properly socketed.
Intel ISP1100 Internet Server Quick Start Guide
A
B
Figure 3. Installing the Processor Chip
D
C
F
E
G
OMO9431
7