Intel ISP1100 Quick Start Manual page 11

Remove the Drive Mounting Bracket
Perform the following procedure to remove the drive mounting bracket from the server chassis
(refer to Figure 6):
1. Grasp the back of the mounting bracket and lift until the bracket releases from the two snaptop
standoffs (A).
2. Slide the mounting bracket back to release the two tabs from the slots (B) in the server front
panel and remove the mounting bracket from the drive bay.
B
Install the Drive in the Mounting Bracket
Perform the following procedure to install the hard drive in the mounting bracket (refer to
Figure 7):
1. Place the drive in the mounting bracket with the component side down and the front of the
drive facing the front (tabbed) end (A) of the mounting bracket.
2. Align the four mounting bracket screw holes (two on each side) with the mating holes in the
drive housing.
3. Use a Phillips screwdriver and four screws (B) to securely attach the mounting bracket to the
drive. Do not overtighten the screws because the bracket sides can bend inward which affects
the alignment of the tabs with the slots in the front panel.
A
Intel ISP1100 Internet Server Quick Start Guide
Figure 6. Removing the Mounting Bracket
B
Figure 7. Installing the Drive in the Mounting Bracket
A
OMO9434
B
OMO9435
11