Intel ISP1100 Quick Start Manual page 14

Install the Add-in Card(s) on the Riser
Perform the following procedure to install add-in card(s) on the riser card (refer to Figure 10):
Before you begin, examine the length of the bracket at the end of the add-in card you wish to
install to determine whether it is a standard or a low-profile type. The low-profile card bracket is
shorter than the standard card; approximately 3.11 in. (7.9 cm) compared to approximately 4.75 in.
(12.06 cm) long. The low-profile card fits into the right expansion slot (when facing the front of
the server) and the standard card fits in the left slot.
1. Align the add-in card edge connector (A) with the proper riser connector (B). For example:
If the add-in card is a standard type (C), the component side faces down and the add-in card
edge connector mates with the connector on the left side of the riser card when the riser is
pointing toward the back of the server.
If the add-in card is a low-profile type (D), the component side faces up and the add-in card
edge connector mates with the connector on the right side of the riser card.
The connectors are keyed to mate in only one direction.
2. Firmly press the add-in card(s) all the way into the mating connector on the riser card.
C
14
A
Figure 10. Installing Add-in Card(s) on the Riser
B
Intel ISP1100 Internet Server Quick Start Guide
D
A
OMO9438