Table of Contents
Advertisement
Statement 26
1. Loosen and remove the mounting screws from both sides of the mounting rail and
2. Place the half shears on the rear side of the foam carriers and use the M3.5
48
NE1064TO Installation Guide
CAUTION:
Do not place any object on top of rack-mounted devices.
To install the 1U air-duct option in a 19" rack, complete the following steps:
set them aside to reuse for securing the foam carrier in the next step.
mounting rail screws to secure the foam carrier assemblies snugly against the rear
of the NE1064TO unit. Torque the screws to approximately 1.1 Nm ± 0.1 Nm (10
inch-pounds).
Half shear
Mounting screws
Note: There are additional M3.5 screws in the air-duct assembly kit.
Foam carrier snug against rear of unit
Reuse mounting screws
Advertisement
Table of Contents
