Table of Contents
Advertisement
Installing the NE1064TO in a Rack
Installing the NE1064TO in a Standard Equipment Rack
© Copyright Lenovo 2020
The NE1064TO can be rack-mounted using one of the following mounting kits:
For a standard 19-inch equipment rack, use the 2-post rack mounting brackets
and screws included with the switch. Installation instructions begin on
For a Lenovo System x or Power 4-post rack, use the Lenovo Adjustable 19"
4-Post Rail Kit. This kit must be purchased separately. Installation instructions
begin on
page
40.
For a Lenovo iDataPlex
purchased separately. Installation instructions begin on
This section describes how to install the NE1064TO in a standard 19-inch
equipment rack using the mounting kit included with the switch. For information
about mounting the switch in other supported racks, see the appropriate section in
this chapter.
The following parts are included in the standard mounting kit.
Table 9.
2-post rack mount kit parts
Item number
Description
1
Mounting brackets
2
M4 screws
3
M6 screws
4
M6 clip nuts
5
M6 cage nuts
Attention: The rack-mounting frame may be unable to support the weight of the
switch with only the front post mounting brackets (2-post application). If the switch
has an undesirable amount of sag, it is recommended to use a 4-post mounting kit.
Attention: For earthquake stability, mount the switch in a 4-post rack.
®
rack, use the iDataPlex mounting kit. This kit must be
Quantity
2
8
4
4
4
Chapter 3: Installing NE1064TO Hardware and Options
page
37.
page
44.
37
Advertisement
Table of Contents
