Table of Contents
Advertisement
5. Attach the rear alignment plate (Item 6) to the rear rack posts with M6 screws (Item
6. If installing the 1U air-duct option, see the instruction on
7. Connect all external cables in accordance with the
8. Initialize the switch. See
46
NE1064TO Installation Guide
3), and clip nuts (Item 4). Torque the screws to approximately 5.7 Nm +/- 0.1 Nm (50
inch-pounds).
4
3
page
36.
6
Chapter 5, "Initializing the
page
47.
"Cabling Guidelines" on
NE1064TO".
Advertisement
Table of Contents
