Wire-Cutting Device Sub-Assembly; Sub-Assembly Accessories And Options - Kemppi A7 Operating Manual

9.3 Wire-cutting device sub-assembly

The wire-cutting device sub-assembly is depicted in the
figure below.
Figure 6: Wire-cutting device sub-assembly
1. Wire-cutting device
2. Protection plate
3. Movable cutting plate
4. Fixed cutting plate

9.4 Sub-assembly accessories and options

This section describes the sub-assembly accessories and options.
Table 8: Sub-assembly accessories
Prism
Milling cutter
Table 9: Sub-assembly options
Maintenance unit
12
© Kemppi Oy 2016
Anti-twist fastening with a cylinder-head screw (M8×20) in the clamping device
(depending on the diameter of the gas nozzle)
Milling cutter dimensions determined on the basis of the gas nozzle and torch
geometry for an immersion depth of up to 50 mm (the cutter is available for all
standard WH and robot torch versions)
ID 830.0075
Unit consisting of a filter regulator and oiler
The function of separating solid particles from the compressed air and adding
atomized oil to lubricate the pneumatically driven components
Robot Gun Cleaning Station 1616