Installing The Injection Unit - Kemppi A7 Operating Manual

10.2 Installing the injection unit

This section describes how to install the Robot Gun
Cleaning Station's injection unit.
The injection unit's parts are depicted in the figure below.
The numbering in the steps of the procedure refers to this
figure.
Figure 10: Injection unit
1. Cover for injection unit
2. Rubber gasket for welding torch's gas nozzle
3. Thrust ring
4. Injection unit, complete
5. Adjusting screw for the dosing of anti-spatter fluid
Proceed as follows:
1. Before you operate the device, mount the rubber
gasket, fitting the gas nozzle of the welding torch.
Figure 11: Rubber gasket
1. Mark the gas nozzle diameter of the welding torch.
2. Loosen the cover (1).
3. Attach the rubber gasket (2) to the cover (1).
Insert the rubber gasket (2) into the cover (1) with light
pressure. The special design of these two components
prevents unintentional dropping of the rubber gasket.
15
© Kemppi Oy 2016 Robot Gun Cleaning Station 1616