Unmounting; Disposal; Materials - Kemppi A7 Operating Manual

Robot gun cleaning station

Hide thumbs Also See for A7:

Table of Contents

15. UNMOUNTING

Unmounting may only be carried out by specialist personnel. Please make sure that the

shutdown procedures are strictly observed before the unmounting is started. Make sure

to include also the components integrated into the welding system.

Risk of injury due to unexpected start-up

For the entire duration of maintenance, servicing, unmounting, and repair work, the

following instructions must be adhered to:

• Switch off the power supply.

• Cut off the compressed air supply.

• Pull the power plug.

Observe the information given in Chapter 11.

For disposal, the locally applicable regulations, laws, provisions, standards, and guidelines

must be observed. For the welding torch system to be properly disposed of, it must be

unmounted first.

This product consists for the most part of plastics, steel, and non-ferrous metals. Steel and

non-ferrous metals can be melted down, so iron materials are almost infinitely recyclable.

The plastic materials used are marked in preparation for appropriate sorting of the

materials for later recycling.

Robot Gun Cleaning Station

1616

Table of Contents