Adjusting The Frame Center - Samsung IER Series Installation Manual

4. Frame Installation – Adjusting the Frame
Center (Important)
•
Install the Frame Center after a Frame Side and two Frame Middles are installed based on the VG-LFR53FWL.
•
Before installing Frame Middle
•
Push the modules to the center and check the Frame Center so that there is no gap between cabinets and
between modules.
• When the module's end is protruded more than 0.5 mm to the right based on the Frame Center, adjust the right
side of Frame Center outward.
• When the module's end is protruded within 0.0 mm to the right based on the Frame Center, adjust the right side
of Frame Center inward.
•
When installed long left to right, repeat the above procedure whenever a Frame Center is installed.
※ Otherwise, it may cause maintenance issues due to difficulty in attachment and detachment of a module.
Excessive attachment may cause the module's dislocation. (see page 26)
Fig.7 (check the gap)
next to the Frame Center, be sure to
Cabinet
LED Module
Gap
hang the IER Cabinet on the bottom line.
Gap
Samsung Electronics
◆Bracket Center's usable section,
VG-LFR53FWL: Every 3 rows
VG-LFR52SWL: Every 3 rows
VG-LFR84FWL: Every 4 rows
Gap is within 0.0 mm Gap is over 0.5 mm
Fig.8 (adjust the gap)
26