6. Settings / How to Use
9-1. PC-specific control software
Network IP Setting Tool
Use the File Explorer to go to the folder where LSM is installed.
Select [Start] – Programs – Samsung – LED Signage Manager – Network
Configuration.
1.
Use the RS232C cable to connect the PC to the S-Box. Select the
connected Serial port and press the Open button to establish a
connection.
The ID of an S-Box is set to "1" by default.
2.
3.
Enter the IP address, subnet mask, gateway and DNS for the S-Box, and
press the Apply button to send the data.
4.
View the result. View the MDC Protocol setting status.
The "Change Type to RJ45" button is displayed if IP settings have been
5.
configured correctly. Connect the LSM to the S-Box. If the product
works properly, press the "Change Type to RJ45" button to switch the
S-Box connection mode to "RJ45."
[★ Caution!] When configuring S-Box network settings, it is recommended
that a static IP address be used.
If DHCP is used and the IP address is changed, the connection with LSM may
be disconnected.
The 192.168.10.x band is used for internal communication with LED cabinets.
Use an IP address that does not belong to this band.
Use the IP address for S-Box (x1) assigned by your IT administrator. Do not
allocate an IP address arbitrarily.
Samsung Electronics
1
2
3
4
55