Samsung IER Series Installation Manual page 60

6. Settings / How to Use
9-1. PC-specific control software
LSM (LED Signage Manager)
•
New Connection-Connect
If using an old version LSB, select "Without Cabinet IP."
1.
If using a UHD LSB, select "With Cabinet IP (UHD)." Make
2.
sure assigning a different IP address for each port
connected LED cabinets. Set the number of connected
cabinets and click "Connect."
If using an FHD LSB, select "With Cabinet IP (FHD)." Set
3.
the IP addresses for the LED cabinets, and the number of
connected cabinets, and then click "Connect."
※ If IP addresses are already set for the cabinets, select the "Connect
with existing settings" checkbox.
※ If using UHD and some of the four ports will only be used, only
enter the IP addresses for the corresponding groups.
[★ Caution!] When configuring LED cabinet network settings, it is recommended that
a static IP address be used.
If DHCP is used and the IP address is changed, the connection with LSM may be
disconnected.
The 192.168.10.x band is used for internal communication with LED cabinets.
Use an IP address that does not belong to this band.
Use the IP address for LED (x4) assigned by your IT administrator. Do not assign an
IP address arbitrarily.
※ Should be different than S-Box / Should be different for each group
※ Should be the same
as S-Box
Samsung Electronics
59