Samsung IER Series Installation Manual page 99

Led display

Hide thumbs Also See for IER Series:

Table of Contents

2-5. IER-F + IER-F L-Type Installation

BRACKET-ALIGN

• When IER-Fs are stacked upward, fasten the Bracket Align that is used to compensate for Z-axis difference between top and bottom

cabinets.

• Remove the bottom module from the upper cabinet and the top module from the lower cabinet.

• Pass the Bracket Align through the hole of the Cover Rear from the top to connect the up and down cabinets and fasten them with screws.

• Connect the modules again.

* Apply Bracket Align for L-type and all IER-F cabinets that are connected vertically.

Fig 29. IER-F Bracket Align Installation Procedure

Samsung Electronics

Bracket Align

(included in the Set)

Table of Contents

Show Quick Links

Table of Contents