Processing Your Food - Gastroback Easy Juicer Fun Operating Instructions Manual

Place the filter basket with the dark base facing downwards in the centre of the pulp
container onto the drive shaft coupling. Then turn the filter basket, until it settles down
and press the filter basket further down, until it engages on the drive shaft coupling
with a click.
Place the cover onto the pulp container with the arrow on the lower brim of the cover
aligned exactly over the arrow on the upper brim of the pulp container. The cover
engages onto the pulp container, when it is assembled correctly.
Fold the two locking arms upwards and hook the locking arms into the protrusions
of the cover. Then lock the locking arms by pressing the lower end of the locking
arms without violence into the motor base. The cover must be locked stable onto the
pulp container now.
Tip: If you cannot lock the locking arms, the cover or pulp container are not assem-
bled correctly. Try again observing the position of the arrows on the parts.
Put the pusher into the feed chute. This can only be done in two orientations.
Ensure that the drip-stop spout of the juice outlet is in the open position with the pro-
trusion facing downwards.
Place the juice jug under the juice outlet. Then close the juice jug with the lid.
However, you may place any other suitable container under the juice outlet.
The appliance is now ready for operation.
Proceed reversely for removing the individual parts.
TIP:

Processing Your Food

Prepare the »Easy Juicer Fun« for operation as described in the section above. Pre-
pare your food (see: 'Tips for Best Results'). Remove all inedible parts and cut your
food in pieces of sufficient size (approx. 5-6 cm).
Ensure that a suitable juice container is placed under the juice outlet and the drip-
stop spout is in the open position.
Insert the power plug of the appliance in the wall power outlet. The ON/OFF button
will flash red.
Touch the ON/OFF button for approx. 5 seconds to switch ON the appliance.
The LCD screen will be activated, showing the already elapsed working time (00:00
on start-up). Additionally, the right speed button
Note:
The delay of 5 seconds for switching ON the appliance is intended as a child safe-
ty interlock to prevent little children from activating the appliance. If you touch the
ON/OFF button in standby mode again, the appliance will switch OFF.
42
starts flashing (standby mode).