Installing The Receiver And Battery; Installing The Switch - Black Horse Model SPACE WALKER Instruction Manual Book

SPACE WALKER -
Bottom side.
Top side.

INSTALLING THE SWITCH.


    
1. Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.

     2. Secure the switch in place using the
two machine screws provided with the radio
system.
24
ITEM CODE: BH65-A.
Switch
Instruction Manual

INSTALLING THE RECEIVER AND BATTERY.


    
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.

    
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.

    
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
picture below.
Do not permanently secure the receiver and
battery until after balancing the model.

     4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
Tie wrap.
Tie wrap.