Black Horse Model SPACE WALKER Instruction Manual Book page 16

SPACE WALKER -
Mark line.
 4. Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
When cutting through the cover-
ing to remove it, cut with only enough pres-
sure to only cut through the covering it's
self. Cutting into the balsa structure may
weaken it. This could lead to possible fail-
ure during flight
Remove covering
Top side
16
ITEM CODE: BH65-A.
Remove covering
Instruction Manual
Bottom side.
 5. When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measure-
ments one more time before the epoxy cures.
Remove any excess epoxy using a paper
towel and rubbing alcohol and hold the stabi-
lizer in place with T-pins or masking tape.
Epoxy glue
Epoxy glue