Black Horse Model SPACE WALKER Instruction Manual Book page 4

SPACE WALKER -
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
 2. Using a modeling knife, remove the cov-
ering servo tray.

3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
4
ITEM CODE: BH65-A.
Bottom side
Bottom side
Remove covering
Instruction Manual
Servo tray
 4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
 5. Instal servo tray with aileron servo into
the wing as same as picture below.
Electric wire
2 x 10 mm.
Secure
Thread