Table of Contents
Advertisement
SPACE WALKER -
C/A glue
Top side
Bottom sie.
6. After the epoxy has fully cured, remove
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
ITEM CODE: BH65-A.
Instruction Manual
ELEVATOR CONTROL HORN INSTALLA-
TION.
Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of elevator.
2x12mm
1) Drill through1.5mm (diameter) the el-
evator using the control horn as a guide and
screw the control horn in place.
Drill a hole
1.5mm diameter.
Secure.
17
Advertisement
Table of Contents
