Installing The Switch, Receiver And Battery - Black Horse Model Antonov An-2 Instruction Manual Book

Antonov An - 2

INSTALLING THE SWITCH, RECEIVER AND BATTERY

Plug the servo leads and the switch lead into
1)
the receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the
switch.
INSTALLING THE SWITCH
The switch should be mounted on the fuselage
1)
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting
holes.
TOP VIEW
56
Item code: BH186
On
Off
Switch
X
Must be purchased
separately!
Wrap the receiver and battery pack in the
2)
protective foam to protect them from vibration. Use
a rubber band or masking tape to hold the foam in
place.
Do not permanently secure the receiver and
battery until after balancing the model.
Cut out the switch hole using a modeling knife.
2)
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
Secure the switch in place using the two
3)
machine screws provided with the radio system.
Receiver
Instruction Manual