SPACE WALKER -
INSTALLING THE THROTTLE PUSHROD.
Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
ITEM CODE: BH65-A.
Right side
Throttle servo
Instruction Manual
COWLING.
1.
Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage.
Secure.
Cut.
Throttle pushrod.
11