Installing The Throttle Pushrod; Installing The Switch - Black Horse Model CAP 232 Instruction Manual Book

CAP 232-
Item code:BH24.
Rudder cable.

INSTALLING THE THROTTLE PUSHROD.

Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to the
bottom nut. This will prevent the connector
from loosening during flight.
secure.
24
Conector.
Servo arm.
Instruction Manual
Throttle pushrod.

INSTALLING THE SWITCH.

1 1. Cut out the switch hole using a
modeling knife. Use a 2mm drill bit and drill
out the two mounting holes through the fuse-
lage side.
1 2. Secure the switch in place using the
two machine screws provided with the radio
system.
Switch
Cut.