Table of Contents
Advertisement
7 Diagnostics on ACT365-VCU
Log in to the ACT365-VCU web interface (see Accessing the ACT365-VCU web interface on page 17) and
click the Diagnostics tab.
From this tab, you can view the VCU Status, the Camera Status for each camera that is connected to the
ACT365-VCU, and the ACT365-VCU Event Log.
You can also perform the following ACT365-VCU maintenance tasks:
Reboot the ACT365-VCU. Click Reboot to shut down services and reboot the ACT365-VCU.
l
Reset the ACT365-VCU to factory defaults. Click Factory Reset to remove all local configuration
l
and reset the unit. You can also reset the ACT365-VCU as described in Factory Reset on page 26.
Identify an individual ACT365-VCU. Click ID Mode and all LEDs on the ACT365-VCU will flash
l
repeatedly. Click again to resume normal operation.
Enable automatic firmware updates. By default, automatic updates are turned off. If new
l
firmware is available, the update must be initiated from the ACT365 Installer Portal. To enable
automatic firmware updates, select the AutoUpdate check box.
Set a unique password for the ACT365-VCU. Enter a new password in the field provided and
l
click Set Password.
Enable Remote Access. To allow Vanderbilt to remotely connect to the unit to perform debug
l
operations, select the Enable Remote Access check box.
Log Power Errors. Voltage fluctuations can cause low power events. To enable voltage monitoring
l
for power, select the Log Power Errors check box.
© Vanderbilt 2019
32
A-100528-b
20.05.2019
Advertisement
Table of Contents
