Factory Reset - Vanderbilt ACT365-VCU Installation And Operating Instructions Manual

ACT365-VCU / ACT365-VCU2A / ACT365-VCUPoE – Installation and Operating Instructions
To configure stream settings, log in to the ACT365-VCU web interface (see Accessing the ACT365-VCU
web interface on page 17), then:
1. Click the Stream Settings tab.
2. Select one of the following options:
Standard stream profile (default setting: 720p, H264, 25fps, 1024 Kbps)
l
High stream profile (1080p, H264, 25fps, 2048 Kbps)
l
Manual stream profile. This profile option is only recommended for experienced camera
l
installers. Customize this streaming profile by editing the Values. Ensure that your manual
settings are supported by your connection bandwidth.
3. Under Recording, select the number of cameras you will connect to the VCU. You can connect a
maximum of four cameras, and recording space on the connected HDD is divided equally between
the selected number of cameras.
Note: This setting is only editable before cameras are added to the system. You must also enable
recording for each camera before the feed will be recorded to the HDD. You can enable recording as
you add each camera. See Adding Cameras using Discovery on page 18 and Adding Cameras
Manually on page 20.
4. Click Save.

5.9 Factory Reset

In the event of a unit failure or forgotten ACT365-VCU password, follow the procedure below to factory
reset the ACT365-VCU.
IMPORTANT: Factory reset removes all custom settings and camera databases. Previous camera
footage is erased. Factory reset is NOT REVERSIBLE and should only be used as a last resort.
You can also perform a factory reset from the ACT365-VCU web interface Diagnostics tab. See
Diagnostics on ACT365-VCU on page 32 for more information.
© Vanderbilt 2019 26
Configuring ACT365-VCU
A-100528-b
20.05.2019