ACT365-VCU / ACT365-VCU2A / ACT365-VCUPoE – Installation and Operating Instructions
Once the password is successfully changed, you may continue with the setup of ACT365-VCU.
5.2 Adding Cameras using Discovery
To add a camera using discovery, log in to the ACT365-VCU web interface (see Accessing the ACT365-
VCU web interface on the previous page), then:
1. Click the Cameras tab.
Automatically discovered cameras are listed in the Discovered Cameras section.
2. Select a camera in the Discovered Cameras list, then click Add.
The Probe Device dialog box displays.
© Vanderbilt 2019
This enforced password change is best practise to ensure the service stays
secure. If you lose your password, perform a factory reset of the unit (see Factory
Reset on page 26). Note that resetting the unit will remove any settings, cameras
and previous recordings.
18
Configuring ACT365-VCU
A-100528-b
20.05.2019