Network Settings On Act365-Vcu - Vanderbilt ACT365-VCU Installation And Operating Instructions Manual

ACT365-VCU / ACT365-VCU2A / ACT365-VCUPoE – Installation and Operating Instructions
4. On the camera feed image, click the top-left and bottom-right points that define the area to be
monitored for motion events.
5. Use the drop-down lists in the Schedule area to configure when motion detection should be active
or inactive during the work week and at weekends.
6. Select the Enabled check box.
7. Click OK.

5.7 Network Settings on ACT365-VCU

The ACT365-VCU is configured to use DHCP addressing by default. You can modify network settings
through the ACT365-VCU web interface.
To configure the ACT365-VCU to use a static IP address, log in to the ACT365-VCU web interface (see
Accessing the ACT365-VCU web interface on page 17), then:
1. Click the Network Settings tab.
2. Under Static IP Settings, set the required addresses for Gateway, IP Address and Subnet Mask.
3. Click Apply to save changes.
The unit reboots. After reboot, the new IP address is in effect.
© Vanderbilt 2019 24
Configuring ACT365-VCU
A-100528-b
20.05.2019