Reset The Act365-Vcu Hardware To Use Dhcp; Stream Settings On Act365-Vcu - Vanderbilt ACT365-VCU Installation And Operating Instructions Manual

ACT365-VCU / ACT365-VCU2A / ACT365-VCUPoE – Installation and Operating Instructions
To configure the ACT365-VCU to use DHCP addressing, log in to the ACT365-VCU web interface (see
Accessing the ACT365-VCU web interface on page 17), then:
1. Click the Network Settings tab.
2. Under Static IP Settings, delete values for Gateway, IP Address and Subnet Mask.
3. Click Apply to save changes.
The unit reboots. After reboot, DHCP addressing is in effect.
You can optionally enter a Site Name and VCU Description in the VCU Information section on
the Network Settings tab. This information helps to identify the units and may assist Vanderbilt
support if you need help.

5.7.1 Reset the ACT365-VCU hardware to use DHCP

If an ACT365-VCU has an invalid IP address, or the unit is no longer accessible on its known IP
address, the red LED will flash on unit boot. You can reset the ACT365-VCU to use DHCP using the
following procedure:
1. Set the DIP switches as follows:
When the blue lights start to flash, this indicates that the IP reset is complete.
2. Set the all DIP switches to OFF.
The unit reboots automatically.
After reboot, the unit is back on DHCP.

5.8 Stream Settings on ACT365-VCU

Video quality can be configured from the Stream Settings tab in the ACT365-VCU web interface. The
settings apply to all cameras connected to the ACT365-VCU. If a particular camera does not support
the selected values, the next available values will be used instead on that camera.
© Vanderbilt 2019 25
Configuring ACT365-VCU
A-100528-b
20.05.2019