Table of Contents
Advertisement
You can access the S4810–ON directly through the console port at the input/output (I/O) side of the system.
Topics:
•
Accessing the RJ-45 console port (RS-232)
•
RJ-45 console port
•
Before you install an operating system
Accessing the RJ-45 console port (RS-232)
The RS-232/RJ-45 console port is labeled on the upper-right-hand side of the S8410–ON chassis (the I/O side), as shown.
NOTE:
Before starting, be sure that you have a terminal emulation program that is already installed on your personal
computer.
Figure 12. S4810–ON Serial Console Port Connector
1. RJ-45 Console Port
The following table lists the console port pinout assignments.
To access the console port:
1. Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S4810–ON console port to a terminal server.
2. Connect the other end of the cable to the dumb terminal emulator (DTE) server.
3. Keep the default terminal settings on the console as follows:
•
115200-baud rate
•
No parity
•
Eight data bits
•
One stop bit
•
No flow control
Console Ports
Console Ports
7
25
Advertisement
Table of Contents
