Table of Contents
Advertisement
Figure 6. Attaching the Mounting Brackets into a Four-Post Rack or Cabinet
1. View from the chassis I/O side
3. Screws
5. Connect to the rack or cabinet (ears)
4. Attach the long bracket to each side of the chassis using the provided countersink screws. Use two screws on each side of the
chassis.
5. Install the rack mount ears into the I/O-facing posts using rack mount screws (not included with the system).
NOTE:
Mount the rack mount ears so that the system is level when fully installed.
6. Using the provided pan head screws, attach the rack ears on the I/O facing posts to the long bracket (attached to the system). To
secure, tighten the pan head screws.
Four-post installation
To install a system into a four-post equipment rack using the already attached mounting brackets, follow these steps.
1. Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and airflow.
2. Install the system into the rack. Ensure the long brackets dock into the previously installed rack ears.
3. Fasten the system to the PSU-facing posts using rack mount screws (not included with the system).
16
Install the S4810–ON
2. Connect to the rack or cabinet
4. Screws
6. Power Supply
Advertisement
Table of Contents
