Table of Contents
Advertisement
Figure 5. Installing the System into a Two-Post Rack or Cabinet
1. PSU1
3. Rack Mounting Ears
Attach the mounting brackets
The S4810–ON ships with mounting brackets (rack ears) and the required screws for a two-post rack or cabinet installation.
To install the S4810–ON in a four-post rack or cabinet, you must order additional brackets separately. Use the brackets that are included
with the S4810–ON on the I/O side of system and use the brackets that you ordered separately on the PSU side of the system.
Unlike the two-post installation, the four-post installation requires attaching brackets to the rack before installing the system.
To attach the brackets to the rack or cabinet, follow these steps.
1. Ensure that there is adequate clearance surrounding the rack or within the cabinet to permit access and airflow.
2. Take the brackets and screws out of their packaging.
3. Attach the brackets to the PSU sides of the chassis using four screws for each bracket. Attach the bracket so that the "ear" is parallel
to the PSU and the outside of the chassis.
2. PSU2
4. Rack or Cabinet Post
Install the S4810–ON
15
Advertisement
Table of Contents
