Table of Contents
Advertisement
To install the S4810–ON system, Dell Technologies recommends completing the installation procedures in the order that is in this chapter.
Always handle the S4810–ON and its components with care. Avoid dropping the system or its field replaceable units (FRUs).
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the S4810–ON and its components. As with all electrical devices of this type, take all the necessary
safety precautions to prevent injury when installing this system.
Topics:
•
Installing the S4810–ON Chassis in a Rack or Cabinet
•
Ground cable
•
Installing the SFP+ and QSFP+ Optics
•
Splitting QSFP+ Ports to SFP+ Ports
•
System power-on
•
After installation
Installing the S4810–ON Chassis in a Rack or
Cabinet
The following sections describe how to install the S4810–ON in a rack or cabinet.
Two-post mounting brackets
The S4810–ON ships with mounting brackets (rack ears) and the required screws for a two-post rack or cabinet installation. The brackets
are sent in a package with the system.
NOTE:
Dell Technologies recommends attaching the brackets at the power supply unit (PSU) side. This set up provides
the greatest weight support for the chassis in the rack or cabinet.
To attach the brackets to the system, follow these steps.
1. Take the brackets and screws out of their packaging.
2. Attach the brackets to the PSU sides of the system using four screws for each bracket. Attach the bracket so that the "ear" is parallel
to the PSU and the outside of the system.
Install the S4810–ON
4
Install the S4810–ON
13
Advertisement
Table of Contents
