Table of Contents
Advertisement
3-8 ELECTRICAL INSTALLATION
3-8.1
Attach right and left hand warning light as-
semblies to warning light brackets already at-
tached to the frame using 1/4-20 x 1-1/4 hex
head cap screws and hex lock nuts. Insure
the wires are in the groove in the base of the
light toward the mounting surface on the
bracket. Assemble one light for left side and
one for right side. The red light should be to
the rear with the amber light being the outer-
most light.
IMPORTANT
MAKE SURE LIGHTS ARE POSITIONED FOR
MAXIMUM VISIBILITY FROM THE REAR.
Figure 3-5 Electrical Installation
3-8.2
3-8.3
3-8.4
3-8.5
Install the rear wiring harness between the
lights
using
extension
necessary.
Install the main short harness and connect
to the rear warning harness.
Insure that the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
Install the stor-away holder bracket on bolt
in coulter clamp plate and assemble harness
stor-away to bracket with 1/4-20 x 3/4 hex
head cap screws and hex lock nuts.
harness
where
3-9
Advertisement
Table of Contents
