Hydraulic Maintenance; Storage - Landoll 1550 Series Operator's Manual

4-8 HYDRAULIC MAINTENANCE

4-8.1 If a cylinder leaks, disassemble the part to
find the cause of the leak. Any time a cylin-
der is opened up, or whenever any seal re-
placement is needed, it is advisable to clean
all parts and replace all seals. Seal kits are
available from your Landoll dealer.

4-9 STORAGE

4-9.1 The service life of the In-row Ripper will be
extended by proper off-season storage prac-
tices. Before storing, complete the following
procedures:
4-9.2 Completely clean the unit.
4-9.3 Inspect the machine for worn or defective
parts. Replace parts as needed to avoid de-
lays the following season.
4-8.2 Check all hydraulic hoses weekly. Look for
binding or cracking. Replace all worn or de-
fective parts immediately.
4-9.4 Repaint all areas where the original paint
film is worn off.
4-9.5 Grease all exposed metal surfaces of
shanks, points, and coulters.
4-9.6 Lubricate as suggested in Section 4-7.
4-9.7 Store the unit in a shed or under a tarpau-
lin to protect it from the weather. The ground
tools and tires should rest on a board or
other device to keep them out of the soil.
4-5