Table of Contents
Advertisement
#1 WHITE
#2 BLACK
#3 YELLOW
FACING CONNECTOR
1/4-20 X 1-1/4 HEX
HEAD CAP SCREW
RH WARNING LIGHT
1/4-20 HEX LOCK
NUT
MAIN SHORT
LIGHT
HARNESS
SELF-LOCKING
TIE
m1550-elect
Electrical Installation
1. Attach right and left hand warning light assemblies to
warning light brackets already attached to the frame
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts. Insure the wires are in the groove in the
base of the light toward the mounting surface on the
bracket. Assemble one light for left side and one for
right side. The red light should be to the rear with the
amber light being the outermost light (See
Figure 3-5.)
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
#7 BLUE
#6 BROWN
#5 GREEN
#4 RED
Figure 3-5: Electrical Installation
2. Install the rear wiring harness between the lights
3. Install the main short harness and connect to the
4. Insure that the harnesses are clear of any moving
5. Install the stor-away holder bracket on bolt in coulter
ASSEMBLY INSTRUCTIONS
7-PIN
CONNECTION
GRND. 1
YEL. 3
GRN. 5
BRN. 6
HARNESS EXTENSION
REAR WIRING HARNESS
1/4-20 HEX LOCK NUT
STOR-AWAY
BRACKET
HARNESS STOR-AWAY
1/4-20 X 3/4 HEX HEAD CAP
SCREW
using extension harness where necessary.
rear warning harness.
parts and secure the harnesses with tie wraps
provided.
clamp plate and assemble harness stor-away to
bracket with 1/4-20 x 3/4 hex head cap screws and
hex lock nuts.
WIRING CHART
4-PIN
CONNECTION
D
B
A
C
HOLDER
RH WARNING
LIGHT
WARNING LIGHT
BRACKET
3-9
Advertisement
Table of Contents
