Storing Autodial And Speed Dial Numbers - Comdial DSU and DSU II System Reference Manual

Programming Your Telephone

10.2 Storing Autodial And Speed Dial Numbers

To store an outside number or a feature code as an autodial or
speed dial number, follow the display prompts and proceed as
follows:
1. Press OPTIONS.
2. Press NEXT until ADIAL and SDIAL is displayed.
3. Press ADIAL to choose autodial programming or SDIAL to
choose speed dial programming.
4. Press programmable button or keypad button to choose storage
location.
5. Press line button to dial out on or press INTERCOM,
—OR—
if your system provides line groups, dial 1, 2, 3, or 4 for line
group 1, 2, 3, or 4, or dial 0 to have the system automatically
choose line for you.
6. Dial any number (up to 16 digits long—include
needed).
NOTE: You may need a pause between numbers to compensate for
differences in response time between your system and the host
system (ask your attendant about this). To store a pause, press
HOLD , then continue dialing. If your system is behind a host
system that needs a hookflash to access a feature, press TAP to
store a hookflash, then continue dialing. Also, you may need to
erase the typed digits appearing in your display to correct them.
If you do, press BKSP once for each digit to be removed.
7. Press SAVE to store number.
8. Press next location button and store next number.
9. Repeat previous step until all numbers are stored,
—OR—
press SPEAKER to end.
To store a system feature access code instead of an outside number,
follow the above procedure except do not make a line selection before
dialing the number. Instead, dial the access code for the feature after
selecting the button location. For example, to program a group call
pick up button, press the programmable button, press INTERCOM,
dial # 4, then press SAVE.
10–4 LCD Speakerphone Reference Manual
GCA70–245
#
and if