Table of Contents
Advertisement
Programming Your Telephone
Storing Autodial And Speed Dial Numbers
To store an outside number or a feature code as an autodial or
speed dial number, follow the display prompts and proceed as
follows:
l
press OPTIONS,
l
press NEXT three times,
l
press ADIAL or SDIAL to choose autodial or speed dial
programming,
l
press programmable button or keypad button to choose
storage location,
l
press line button to dial out on or press ITCM,
•l
l
if your system provides line groups, dial 1,2,3, or 4
for line group 1,2,3, or 4, or dial 0 to have the system
automatically choose line for you,
l
dial any number (up to 16 digits long - include 3(c and # if
needed),
NOTE: You may need a pause between numbers
to compensate
for dif-
ferences in response time between your system and the host sys-
tem (ask your attendant about this)). To store a pause, press
HOLD, then
continue
dialing. Ifyour system is behind a host
qstem that needs a hookflash to access a
feature.
press TAP to
store a hook$ash, then continue dialing. Also, you may need to
erase the typed digits appearing in your dLplay to correct them.
If you do, press BKSP once for each digit to be removed.
l
press SAVE to store number,
l
press next location button and store next number,
l
repeat previous step until all numbers are stored,
II
l
press SPKR to end.
To store a system feature access code instead of an outside
number, follow the above procedure except do not make a line
selection before dialing the number. Instead, dial the access code
for the feature after selecting the button location. For example,
to program a group call pick up button, press the programmable
button, press ITCM, dial # 4 then press SAVE.
. .
_:
50
Advertisement
Table of Contents
