Moving From Transport To Operating Position - SaMASZ UNO 410 Operator's Manual

The guard should be protected against rotating by securing the shaft set chains to immovable parts of
the tractor and the rake.
CAUTION:
Handle all parts with utmost care. Never place your hands or fingers between one
part and the other. Wear safety clothes such as gloves, protective footwear and
goggles. The operation of shortening must be carried out with the utmost care as the
PTO shaft will have to be replaced if the telescopic shafts are shortened to an
excessive extent.
CAUTION:
The PTO shaft should be mounted only during operation time and disconnected from
tractor PTO for transport and service.
NOTICE:
The manufacturer declines all liability for damage caused by an incorrectly fitted or used PTO shaft.
CAUTION:
Use the machines with PTO shafts designed to drive them. Before the work begins,
check the safety guards (in tractor, rake and PTO shaft), if they are placed correctly
and are not damaged. Damaged or lost parts must be replaced with original ones.
Make sure the PTO shaft is properly mounted. Do not approach the rotating parts,
because it may lead to serious injuries or even death. All service and repair works must
be done only after the tractor engine has been stopped and ignition key removed, all
rotating parts have come to the complete standstill and rotors are on the ground.
Before the operation begins, read operator's manuals of both the machine and PTO
shaft.
NOTE:
When changing the tractor, with which the machine operates, control the length
of U-joint shaft again, as otherwise the machine can be damaged.

5.5. Moving from transport to operating position

WARNING:
Moving the rake to and from operating position from the transport position
should only take place on even and stable ground. Prior to making the moves
make sure whether there are no unauthorized persons exposed to any
hazardous moving parts.
22
UNO
Fig. 17. Instruction of PTO shaft shortening
ROTARY RAKE OPERATOR'S MANUAL