Preparing Rake For Transport On Public Roads; Mounting And Shortening Pto Shaft (Wpt) - SaMASZ UNO 410 Operator's Manual

Gear's vertical
axis
F
WARNING!
Driving speed should be adjusted to current road conditions. Too high
a transport speed when driving on uneven ground poses risk of bending gear's
vertical axis.

5.3. Preparing rake for transport on public roads

WARNING:
Legal requirements for transport on public roads may differ from state to state.
Check your location's requirements and comply
To comply with safety precautions concerning transport on the public roads the rake should be
equipped with the following devices:
portable warning light plates to be mounted on both sides of rake's top guard in their holders.
❑
The panel consists of warning plate with combined lamp mounted (parking, stop lights and
driving direction) and with red reflectors facing the rear and white light on the front.
When transporting on public roads respect provisions valid in the country of use.

5.4. Mounting and shortening PTO shaft (WPT)

The machine is delivered with a separate instruction manual for PTO shafts.
Prior to commencing operation, examine and adjust length of PTO shaft, which is designed to
mount machine on tractor. In some cases it is possible, that the shaft is too long and therefore needs
to be shortened, so that there is adequate tolerance for the shortest possible distance between tractor's
shaft O and machine's shaft P.
Shaft length should be adjusted individually for tractor, on which the machine is mounted.
20
Fig. 13. Rake's transport position with four arms dismounted
UNO ROTARY RAKE
v
.
OPERATOR'S MANUAL