Lubrication; Risks When Lubricating The Machine; Gear - SaMASZ UNO 410 Operator's Manual

OPERATOR'S MANUAL ROTARY RAKE
Tab. 4. Torque values for bolts

7. LUBRICATION

7.1. Risks when lubricating the machine

To avoid being splashed with pressurized liquid wear protective eyewear with side guards.
❑
When lubricating protect eyes and skin against contact with the substance. Therefore use adequate
❑
protective wear with long sleeves and protective shoes. Use protective gloves, too. In case of a
contact with skin, immediately wash the infected area with plenty of soap water.
Do not allow the product to contaminate water outlets, water courses and soils.
❑
In case of an unintentional release to the environment plug the leak, limit the spillage, and then
❑
collect the oil with non-flammable absorbent material (e.g. sand).
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam, water
❑
mist, extinguishing powders). Do not use water jets.
Disposal of the used product must be made according to official regulations. Improper disposal of
❑
the used oil poses danger to the environment.

7.2. Gear

On daily basis prior to work commencement check the oil level and, if needed, refill. The oil level
can be checked by the check opening B (Fig. 25). If the oil level is too low, refill the oil until it is visible
in the check opening B. To drain oil use plug C.
To replace oil in gears:
Prepare an adequate tank for the used oil to be disposed,
❑
Open fuel cap A and the drain plug C,
❑
Drain oil from the gear,
❑
Close drain plug C,
❑
Refill the oil level until it is visible in the check opening B,
❑
Close fuel cap A.
❑
UNO
29