Operation - LawnMaster CLGT6014A Operator's Manual

OPERATION

INTENDED USE
This grass trimmer CLGT6014A is with rated battery voltage of 60V. 60LFC01-ETL designates the
respective charger with a charging voltage of 60V.
The product is intended for cutting weed, grass or similar soft vegetation in areas that are hard to
reach, e.g. under bushes, on slopes and edges. It may not be used to work on unusual thick, dry or
wet grass, e.g. pasture grass, or to shred leaves.
This product is intended for private domestic use only, not for any commercial trade use. It must not be
used for any purposes other than those described.
ON/OFF SWITCH (See Figure 6)
■ Push the lock-off switch (4) forward and hold it in position (Fig. 6).
■ Press the on/off switch (3) to switch the product on (Fig. 6). The lock-off switch can then be
released.
■ Release the on/off switch to switch the product off.
VARIABLE SPEED CONTROL
■ The grass trimmer features a variable speed control.
■ To get higher cutting speed, apply more pressure to the on/off switch; to get lower speed, apply less
pressure to the switch. Adjust the speed to suit the task at hand.
CUTTING DEVICE - ADVANCING THE TRIMMER LINE
In order to advance the trimmer line, firmly tap the bump cap on the trimmer head while the trimmer
is running. This will automatically advance a new length of trimmer line and trim the line to the
correct length. A firm but gentle motion should be used when tapping the bump cap on the lawn. This
advancing process may be repeated as often as necessary. Never try to advance the line on a hard
surface such as a sidewalk or driveway. If unit fails to advance, stop the trimmer and remove the
battery pack, then clean the bump cap both inside and out.
16
Fig 6