LawnMaster CLGT6014A Operator's Manual page 15

BATTERY PACK AND CHARGER
WARNING
If any part of the charger is missing or damaged, do not operate it! Replace the charger with a new
one. Failure to heed this warning could result in possible serious injury.
Check the voltage! The voltage must comply with the information on the rating label.
■ Align the slot of the battery pack with the rail on the charger. Slide the slot onto the rail until the
battery pack secures into place (Fig. 5).
■ Connect the charger to the power supply.
■ Allow sufficient charging time (see Specifications), and then disconnect the charger from the power
supply.
■ Press the release button on the battery pack and remove it from the charger.
NOTE: It is normal for the battery pack and the charger to become warm (but not hot) during charging
process. If the battery does not charge properly, check to make sure the electrical outlet is operational.
Always charge the battery before storage!
15