Operation - LawnMaster CLHT2452-01 Instruction Manual

OPERATION

Battery Pack Operation
WARNING
Use only with 24V Lawnmaster
HYCH0132400500G (UK), 24LFC12-01 (UK) or 24LFC12-03 (EU).
The battery charger supplied is specifically designed for the lithium-ion battery used in this garden
appliance and may cause risk of fire if used with a non-compatible battery pack.
Check the power voltage! Battery chargers operate on 100-240V AC.
Ensure the battery is charged between 4°C and 40°C. This ensures an optimum battery service
life.
Protect the battery from heat, from continuous exposure to sun and keep away from radiation
or other heat sources. Do not leave the battery in the hedge trimmer in direct sunlight over long
periods. The battery is supplied partially charged. To ensure full capacity of the battery, charge
the battery before using your appliance for the first time. The lithium-ion battery can be charged at
any time without reducing its service life. Interrupting the charging procedure does not affect the
battery.
Charger Operation (See Fig. 2)
WARNING
Use only with 24V Lawnmaster
If any part of the charger is missing or damaged, do not operate it! Replace the charger with a new
one. Failure to pay attention to this warning could result in possible serious injury.
Check the voltage! The voltage must comply with the information on the rating label.
■ Align the battery pack to the slots on the charger. Slide the battery pack in until it locks into
place (Fig. 2).
■ Connect the charger to the power supply.
■ After the battery is charged, it is suggested that the charger be disconnected from the power
supply.
■ Press the release button on the battery pack and remove it from the charger.
NOTE: It is normal for the battery pack and the charger to become warm during charging process.
If the battery does not charge properly, check to make sure the electrical outlet is operational.
Always charge the battery before storage!
®
Chargers: MX 24V HYCH0132400500B (EU),
®
MX 24V 24LB2004-C or MX 24V 24LB4005-C battery.
18