Briggs & Stratton 2691266-00 Operator's Manual page 15

Electronic Panel (if equipped)
The electronic panel displays the operating status of a
variety of equipment and engine parameters, and provides
clock and timer functions for oil and air filter maintenance
and for tracking work hours. Data is retained if the battery is
disconnected or power is otherwise interrupted.
NOTE: The Deck Height display requires a wire harness
connection between the deck and the tractor.
this connection is made when reinstalling the deck after
maintenance or the Deck Height display will not function.
See Figure 3 for the location of the Electronic Panel
functions.
A – Control Buttons – MODE (top button), UP (center
button), and DOWN (bottom button).
B – Clock Display – 12-hour clock with am/pm.
C – Blade Icon – illuminates when the Power Takeoff
(PTO) is engaged.
D – Tractor Icon – illuminates when the cruise control is
engaged.
E – Message Display – alerts operator to maintenance
requirements.
F – Parking Brake Icon – illuminates when the parking
brake is engaged.
G – Headlight Icon – illuminates when the headlights
are on.
H – Hour Meter – displays total accumulated run hours
by default; trip hours when MODE button is pressed.
I – Fuel Level – illuminated bars indicate approximate
level of fuel in the tank; at two bars the fuel pump
icon will flash, reminding you to add fuel.
J – Tachometer with Best Cut Range – indicates
engine speed from 1000 to 4000 RPM; the Best Cut
Range indicates optimum performance between
engine speed and deck height settings
K – Deck Height – illuminated bars indicate approximate
height of the deck while mowing.
Timer and Clock Settings
The Hour Meter (H) displays total accumulated run hours
by default. It will automatically reset to zero when the meter
reaches 1999.9 hours.
TRIP HOURS – Press the MODE button once to display
Trip Hours. Press the MODE button again and hold for 3
Ensure
seconds to reset the trip hours to zero.
OIL HOURS – Press the MODE button twice to display
Oil Hours. Press the MODE button again and hold for 3
seconds to reset the oil hours to zero after the oil and filter
have been changed.
AIR FILTER HOURS – Press the MODE button three times
to display Air Filter Hours. Press the MODE button again
and hold for 3 seconds to reset the air filter hours to zero
after the filter has been cleaned or changed.
CLOCK SET – Press the MODE button four times to adjust
the clock. Press the MODE button again and hold for 3
seconds to flash the hour, then press the UP or DOWN
button to change the hour. (AM and PM will change when
the hour setting is adjusted past 12 o'clock.) Press the
MODE button once to flash the minutes, then press the UP
or DOWN button to change the minutes. After adjusting the
hours and minutes, press the MODE button once more to
return to the normal clock display.
NOTE: If the MODE button is not pressed after five
seconds, the selected display will not reset and the hour
meter will return to total accumulated hours.
Maintenance Messages
LOW BATTERY – This message will appear any time
a battery voltage problem occurs. The display will
automatically clear itself after the battery has been serviced.
OIL CHANGE – This message appears after 50 hours of run
time since the previous reset. After changing the oil and oil
filter, press MODE twice to display OIL HRS, then press and
hold the MODE button for 3 seconds to reset the timer to
zero and clear the display.
CHECK AIR FILTER – This message appears after 25
hours of run time since the previous reset. After cleaning or
changing the air filter, press MODE three times to display
AIR FILTER HRS, then press and hold the MODE button for
3 seconds to reset the timer to zero and clear the display.
NOTE: When the LOW BATTERY message appears, it has
priority over any other messages. Service the battery first,
then check for other maintenance messages.
en
15