Table of Contents
Advertisement
2.4 Installing Driveline
Refer to the correct topic below for your model:
•
2.4.1 Installing Driveline – FM100, page 11
•
2.4.2 Installing Driveline – CA20 and CA25, page 13
2.4.1 Installing Driveline – FM100
WARNING
To avoid injury or death from unexpected start-up of machine, always stop engine and remove key from ignition before
leaving operator's seat for any reason.
IMPORTANT:
If the combine output shaft splines match the float module
input shaft splines, ensure the driveline is installed with the
shorter guard (A) at the combine end and the longer
guard (B) at the float module gearbox end.
1. Position the combine end of driveline (A) onto storage
support (B). Pull back collar (C) on the driveline and slide
the driveline onto the support until it locks in place. Release
collar (C).
2. For drivelines equipped with safety chains, attach chain (D)
at the combine end to driveline storage support (B).
214923
INSTALLATION INSTRUCTIONS
Figure 2.13: Driveline Halves
Figure 2.14: Combine End of Driveline
11
A
A
B
C
B
D
Revision A
Hide quick links:
Advertisement
Table of Contents
